Tekmos Communications logo

phone icon
+44 (0)1624 818275
  • Home Icon link to Home Page
  • Baluns and Balun Panels
  • Through Coupler Panels
  • Connectors
  • Cables
  • Bespoke
  • Contact
  • About Us
  • FAQs
  • Home >
  • OEM >
  • JDSU >
  • Splitters >
  • Single Port Splitter Module

Single Port Splitter Module

[Photo of Single-Port Splitter]

The Single Port Splitter Module allows daisy chaining SS7 Cardcages or RTMs without the need for special cables. The Splitter Module accepts 16 E1/T1 physical bearers and presents them on the Output Connectors.

A range of 120 ohm Cables are available for connecting from the network to the Splitter Module and from the Splitter Module to the Cardcage or RTM or another Splitter Module.

Use the Single Port Splitter Module with integrated 130 ohm termination resistors as the last module in the chain.

Use one Splitter Module to present the same physical beares to two cardcages/RTMs

The Splitter Module is transparent to all data protocols and software.

The Splitter Modules are suitable for installations where the network access points will be daisy-chained to more than one acceSS7 Cardcage and the Cardcage contains 4 or fewer Cards. In similar circumstances with 4 or more Cards the Multi-Port Splitter Panel is recommended.

Part NumberDescription
TK-USP16-001-AOOSplitter Single Port
TK-USP16-001-BOOSplitter Single Port with 130 ohm terminations

© Tekmos Communications Limited 2019. All rights reserved.

This website uses cookies to track your visit. You should disable cookies in your browser if you do not want your visit tracked.

Terms