Multi-Port Splitter Panel

The Splitter Panel takes the 96 bearers from a Tekmos Balun Panel and presents them on the "A" and "B" connectors for onward connection. The last Splitter Panel in the chain has 130 ohm terminating resistors across the pairs of interface "B", this Splitter must be located within 1 metre of the final acceSS7 Cardcage. Connectors are female 50 Way Amp, standard 120 ohm Cables are available for connection to acceSS7 Cardcages or additional Splitter Panels.

Use one Panel to link two fully populated acceSS7™ Cardcages. The built-in 130 ohm terminating resistors provide a tried and tested method of terminating the chain, without the need for special cables. Designed to operate at 10MHz without corruption, the design has been tested between two operational Cardcages without affecting the integrity of the transmission path.

Theis panel is suitable for installations where the network access points will be daisy-chained to more than one acceSS7 Cardcage and the Cardcage contains 4 or more Cards. In similar circumstances with 4 or fewer Cards the Single Port Splitter Module is recommended.